Steering Wheel Replacement

S

Swee Pea

Member
Joined
Nov 2, 2003
Messages
405
Reaction score
0
C Dory Year
2004
C Dory Model
22 Cruiser
Vessel Name
Swee Pea
Before I decide to replace the steering wheel on my 22'Cruiser, are there any "tricks"? Do I need a steering wheel puller? Also, shaft diameter so if I decide to replace it, I get the correct fitting wheel.
Thanks in advance.

John
Swee Pea
 
A puller would be in order, once the wheel is off you'll find a standard 3/4" tapered shaft. I swapped mine out for a smaller Boaters World white plastic jobbie. The old wheel wasn't to eager to give up it's post but a two jaw puller convinced it. I sure like the smaller wheel
 
Some of he standard type replacement wheels are of larger diameter than the original factory supplied ones. If you go for a larger diameter wheel, it will decrease the clearance between your thighs and the wheel. Check the current fit out and compare the present diameter wheel you have with the replacement wheel. Can you accommodate the larger one? Joe.
 
A little marine grade grease on the taper will help get it off easier next time. :wink:
 
Sorry, Folks - Post Deleted By Author
 
Dan-

Was the 12'' diameter the OEM on your old boat? I've never seen a 12" wheel on a CD! My original 13 1/2" was replaced with a 14 1/2" which seemed a bit tight at first, but better in the long run. Joe.
 
Sorry, Folks - Post Deleted By Author
 
Thanks for all the input. As always, it is best to ask the group first before proceeding. I will measure, borrow a steering wheel puller, and proceed. :lol:

John
Swee Pea
 
Back
Top