Suzuki Engine Interface (EP20,NEMA 2000) and Raymarine E80

P

petemos

New member
I just installed a Suzuki Engine Interface on the boat and I can't seem to get the Oil Pressure gauge to work. Also my Engine Trim only shows in 20% increments, which is kind of useless. Other than these two things all is well.

Anyone have a EP-20 installed with a Raymarine C or E unit and have the same issues? Or does anyone know if the EP-20 supports Oil pressure?

Thanks Jim
 
The model and year of the motor will limit what works and what doesn't.
Mine is a DF115 and I get Tach, trim, Volts, fuel flow, fuel remain, fuel used, range, GPS functions with the sensor. My motor is a 2007 the newer motors might do more.
 
And for sure the older motors do even less. My suzi 115's are 2001, the first year made and it would interface with that unit but send such sparse info that it wasn't worth it for me.

Charlie
 
OK, well my is a 115 DF 2007, so It must me a limitation of the engine for Oil pressure and not the unit, unless a new Firmware upgrade will do it. Anyone with a Raymarine E or C unit have any luck with getting Trim increments of less that 20%?

Thanks Jim
 
Thanks Matt. On the Suzuki 4 inch Multi-Function Gauge that also interfaces with the EP-20 I get 1% increments, it's the Raymarine E80 that's showing 20%. I'll go back to the E80 and see if there is a scale setting that changes to 1%.

Thanks Again.
Jim
 
Back
Top