LuckeCatanias
Member
- Joined
- Apr 17, 2025
- Messages
- 49
- Reaction score
- 15
- Location
- Edmonds
- C Dory Year
- 2005
- C Dory Model
- 25 Cruiser
- Hull Identification Number
- CD025115D505
- Vessel Name
- Pearl
This winter will be a project to refresh the electrical on the boat.
My first step in this process is to draw out a detailed diagram for my transom wiring.
There will be a separate effort to address everything forward of there.
There will be a separate effort in terms of actual build configuration. I think I'm going to utilize the center transom area (I have a deleted blackwater tank) so I have lots of room to have a tidy install.
This is my proposed configuration, I wonder if anyone can spot any errors or mistakes.
I wonder too if it's reasonable to pay a marine electrician to simply review my installation plan for correctness.
I've included fuses in certain locations. Not on anything that could carry a cranking load.
Note I have a VSR and combiner switch.
The numbers adjacent to each run indicates the gauge. Where blank I've just yet to fill it in.
I've yet to size the busses.
My first step in this process is to draw out a detailed diagram for my transom wiring.
There will be a separate effort to address everything forward of there.
There will be a separate effort in terms of actual build configuration. I think I'm going to utilize the center transom area (I have a deleted blackwater tank) so I have lots of room to have a tidy install.
This is my proposed configuration, I wonder if anyone can spot any errors or mistakes.
I wonder too if it's reasonable to pay a marine electrician to simply review my installation plan for correctness.
I've included fuses in certain locations. Not on anything that could carry a cranking load.
Note I have a VSR and combiner switch.
The numbers adjacent to each run indicates the gauge. Where blank I've just yet to fill it in.
I've yet to size the busses.