Boat Lift Bunk Input

SEdowneast

New member
Joined
Apr 2, 2025
Messages
15
Reaction score
2
Location
Lake Murray, SC
C Dory Model
23 Venture
Hello fellow C Brats. I was looking for some input from those who keep their C Dory's on a boat lift. I keep my Venture 23 on a lift with two bunks where the lumber is set on flat edge with a 7-8 degree angle that has been ripped into the lumber to accommodate the increasing dead rise from stern to bow. On top of that is a thin rubber strip and carpet. What I've found is that the boat does not want to sit flat on parallel bunks. Generally the stern lifts up as the boat rocks forward. I believe this because the hull slopes down from stern to bow and this was based on the measurements of the trailer bunks with the boat on it. The boat sits flat on the trailer bunks for 9 feet. I am thinking that this may only be the case on the Venture's hull, not the other Cruisers because of the different hull design.

I have been able to achieve a level hull sitting on the bunks when I pinched in the forward bunk brackets a few inches each side. However, I believe there was too much pressure where the pinching was, as the bunk carpet was getting very compressed in that area and I had some rubber transfer that left marks as well. The marks came off easily, but to me I felt that was something I should address.

My plan to solve this was to raise the front lift bunks to match the trailer set up. However, before I did anything, I thought I might reach out to see if anyone has run across this issue on a Venture or even a Cruiser and how it was handled. Also, for those that have boats on lifts, I would be curious how well the hull contacts the boat lift bunks.

Thanks so much!!
Bobby
 
Perhaps the easiest way to handle this is to put the flat surface of the bunk pank (the 8” of the 2 x 8). Allow the bunk supports to articulate or “warp” to match the angles of the hull. to allow the plank to twist with the shape of the boat’s hull.

Often the smaller two front bunks are “target bunks” to halp the boat self align on the trailer. They may not acquire the weight of the boat on the trailer.

In the C Dory, the greatest weight is aft: engine/engines, fuel tanks, batteries etc. You can adjust the trim of the boat by where you store other items. For example, I hae often removed the foam from under the forward V berth sleeping platform, and there is a lot of storage space there.
 
Hi Bob! I agree with you completely about articulated bunks! I'd love to find those type brackets that would fit on my beams and go that route. Unfortunately, I've looked a lot and have been unable to do so. Thus, I am afraid I will have to live with the fixed brackets and vertical lumber. I'll keep my fingers crossed that raising the forward bunks up a bit will sit the stern down. We'll see once the water comes back up and the boat goes back to the lift.

Take care!!
 
Below is a photo of a boat on a trailer showing both methods of support. The outer bunk is set on its edge, and has a rounded angle fixed on its inner edge--this is sort of “universal” for the angle--but can be shaped to fit the hull exactly.

The inner bunk is set flat and on an articulating support, which can vary in its degree of flex and exactly match the hull giving better support. It takes some adaptors to match the framework of your lift.

1795321990167.png
 
Back
Top