Media added by clayhubler

Navigation

    1. @C 61
    2. Coho 154
    3. pcg 122
      1. Mods 132

Browse albums
cabin floor ground down

cabin floor ground down

  • Reaction score 0
  • Comments 0
grinder was too aggressive, should have used a sander

grinder was too aggressive, should have used a sander

  • Reaction score 0
  • Comments 0
panel is made and trimmed

panel is made and trimmed

  • Reaction score 0
  • Comments 0
making a panel

making a panel

  • Reaction score 0
  • Comments 0
making a panel

making a panel

  • Reaction score 0
  • Comments 0
after peeling off the plastic

after peeling off the plastic

  • Reaction score 0
  • Comments 0
Taking a look

Taking a look

  • Reaction score 0
  • Comments 0
Sea trials at Swantown in Olympia

Sea trials at Swantown in Olympia

  • Reaction score 0
  • Comments 0
second layer in and weighted down, boat hook keeps the blocks from sliding downhill

second layer in and weighted down, boat hook keeps the blocks from sliding downhill

  • Reaction score 0
  • Comments 0
first layer

first layer

  • Reaction score 0
  • Comments 0
two layers of 3/4 balsa

two layers of 3/4 balsa

  • Reaction score 0
  • Comments 0
ground and cleaned with acetone

ground and cleaned with acetone

  • Reaction score 0
  • Comments 0
getting ready to lay the balsa

getting ready to lay the balsa

  • Reaction score 0
  • Comments 0
heater going inside and warming it up

heater going inside and warming it up

  • Reaction score 0
  • Comments 0
inside the $100 wedding tent

inside the $100 wedding tent

  • Reaction score 0
  • Comments 0
door hinges are loose and the core is a little wet

door hinges are loose and the core is a little wet

  • Reaction score 0
  • Comments 0
holes to dry the sole

holes to dry the sole

  • Reaction score 0
  • Comments 0
the inside of the 'repair'.  I cannot tell from the outside, they did good finish work

the inside of the 'repair'. I cannot tell from the outside, they did good finish work

  • Reaction score 0
  • Comments 0
used the aluminum tool I made in the drill to remove the core

used the aluminum tool I made in the drill to remove the core

  • Reaction score 0
  • Comments 0
had to take more out of the transom.

had to take more out of the transom.

  • Reaction score 0
  • Comments 0
Back
Top